11
While the Control Station is displaying the value at a location, you can enter digits to change the value at that location. The
new value is displayed as you enter the digits. Other keys work as follows:
ENTER - if pressed after new digits are entered, the displayed value is stored at the current location.
- if pressed with no new digits entered, then it will go to the next location.
‘C’ Key - if pressed, it will go back one location and ignore any digits entered.
CLEAR - if pressed after new digits are entered, erase those digits and re-display the original value at the location.
- if pressed with no new digits entered, then it will return to the LOCATION prompt.
OFF CANCEL - on an LED or SSD Control Station, it will momentarily display the present location number.
NOTE
When you press the ENTER key to store the new value, the system will store the value as entered.
It is the responsibility of the programmer to enter a value within the specified range. If the value
entered is out of the range, then undesirable operation may occur. In some cases, if the value
entered is too large, it will be truncated before it is stored causing a different value to be stored than
was entered.
After entering programming mode, press the ‘3’ key to enter Edit Function Map mode. The Control Station will prompt you
for a location to be programmed. The location numbers, definitions, and valid entries for the locations are described in
Section 3.2. From this mode, you may edit the entire Function Map except for User Codes and Zone Names. Editing Zone
Names is described in Section 3.1.4. Editing User Codes is described in the appropriate User Guide, but is not accessible
with the installer passcode.
From the LOCATION prompt, enter digits for the desired location number. The digits entered will be displayed. If more
than three digits are entered, the first digit entered will be discarded. If you make a mistake, you may press the CLEAR key
to clear out the location and start over. When the desired location number is displayed, press the ENTER key. The Control
Station will then display the current value programmed at that location.
3.1.3 Edit Function Map
If the ENTER key is pressed, all changes that were entered will be range checked. The entire time and date need not be
entered. Any fields that are not entered will remain unchanged. If the data entered is within range parameters, the clock will
be updated and the Control Station will return to idle. A “Begin Set Clock” event will indicate the time before the change
and an “End Set Clock” event will indicate the time after the change. If the entered data is out of range, the Control Station
will indicate an error, erase the previous entries and re-display the current time and date.
3.1.3.1 Entering a New Value at a Location
When the location being programmed is an account code or telephone number digit (see Sections 3.2.8 and 3.2.9), the value
will be displayed as an “H” followed by a single digit. The “H” indicates that this location is a Hexadecimal field. The valid
entries for these locations are “0” through “F”, where A - F correspond to 10 - 15 respectively.
To program a digit, enter digits as normal. To enter an A - F, enter a ‘1’ followed by a ‘0’ through ‘5’.
As in programming normal fields, if too many digits are entered, the first digit entered will be discarded. The ENTER, OFF
CANCEL, ‘C’, and CLEAR keys will work the same as described above.
3.1.3.2 Programming Account Code and Telephone Number Digits
INVALID SETTING
WWW.DIYALARMFORUM.COM
(64 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce